Copyright © 1993-2024 CFM Performance. All Rights Reserved.
Kodiak ATV Lift Kit 2" $19.95
All of our products are proudly 100% Made in the USA.
CFM Performance has been serving the powersports community since 1993.
You can buy from us with confidence knowing that we will be here after the sale.
Everything that we sell is our own original design.
Beware of cheap imitations, other sellers selling these have copied our idea, design and many have even stolen our installed picture.
Item For Sale:
Billet aluminum lift kit for Yamaha Kodiak.
Will fit any model, year and engine size.
Features and Benefits:
Will give you about 2" of lift depending on model and shock settings.
They are sold in sets of 4 spacers, 1 for each shock.
Will work with stock shocks only.
Made from 7075 series aluminum. The same strength as steel, but lighter and much more corrosion resistant.
Ride quality is similar to stock.
Still have the ability to adjust preload.
Eliminates sag in the stock springs.
Drastically reduces brake dive and corner roll.
Increases load capacity.
No modifications are necessary to any of your stock components.
Spring compression is required. You will need a coil spring compressor or other method of compressing the springs.
How it Works:
A 1" spacer lifts the ATV about 2" because of the geometry of progressive rate suspension. With stock springs, the weight of the ATV will compress the springs about 1", lowering the ATV about 2". With this lift installed, the weight of the ATV will not compress the springs as much, resulting in an increase in ground clearance of about 2".
Installation Instructions:
Remove the shocks from the machine. Compress the springs. There is a "C" shaped collar that holds the spring to the shock body. When you compress the spring, this "C" shaped collar will fall off. Slide the lift spacer on the shock body and replace the "C" shaped collar. Reinstall the shock.
Yamaha Kodiak 700 Intake Air Box $199.95
All CFM Performance products are proudly MADE IN USA.
Guaranteed to be the most powerful air box/ intake that you can buy for your Kodiak 700, or your money back.
Will fit 2016 and newer Kodiak 700.
It is made from 5052 aluminum for high strength, light weight, and incredible corrosion resistance.
Hardware is stainless steel.
No modifications are required.
Install with basic hand tools in less than 30 minutes.
Removable vent chambers on the front of the air box are not connected to the filtered air that is entering your engine. This allows several options. You can remove them or leave them on and attach your stock vent hoses. The vent chambers can be left open or you can add foam filter material to them. If you choose to add foam filter material to the vent chambers, you will need to supply your own.
The inside diameter of your stock filter is only 3" and it's held in place with the lid. As we all know, it's a poor design that will allow dirt into your engine.
This air box uses a filter with a 4" inside diameter filter that is clamped to a heavy duty aluminum ring providing a perfect seal every time.
This air box does not come with a filter.
You will need to purchase a UNI filter part number NU-4102ST or K&N filter part number HA-4250.