Honda Pioneer 500, 700, 700-4, and 1000 Lift Kit  $19.95

All of our products are proudly 100% Made in the USA.

CFM Performance has been serving the powersports community since 1993.

You can buy from us with confidence knowing that we will be here after the sale.

Everything that we sell is our own original design.

Beware of cheap imitations, every other eBay seller selling these has copied our idea, design and many have even stolen our installed picture.



Item For Sale:

Billet aluminum lift kit for Honda Pioneer 500, 700, 700-4 and 1000.

Will not fit Pioneer 1000-5.



Features and Benefits:

Will give you about 2" of lift depending on model and shock settings.

They are sold in sets of 4 spacers, 1 for each shock.

Will work with stock shocks only.

Made from 7075 series aluminum. The same strength as steel, but lighter and much more corrosion resistant.

Ride quality is similar to stock.

Still have the ability to adjust preload.

Eliminates sag in the stock springs.

Drastically reduces brake dive and corner roll.

Increases load capacity.

No modifications are necessary to any of your stock components.

Spring compression is required. You will need a coil spring compressor or other method of compressing the springs.



How it Works:

A 1" spacer lifts the UTV about 2" because of the geometry of progressive rate suspension. With stock springs, the weight of the UTV will compress the springs about 1", lowering the UTV about 2". With this lift installed, the weight of the UTV will not compress the springs as much, resulting in an increase in ground clearance of about 2".


Installation Instructions:

Remove the shocks from the machine. Compress the springs. There is a "C" shaped collar that holds the spring to the shock body. When you compress the spring, this "C" shaped collar will fall off. Slide the lift spacer on the shock body and replace the "C" shaped collar. Reinstall the shock.
Copyright © 1993-2021 CFM Performance. All Rights Reserved.
Pioneer